Riegelsville Bridge

Riegelsville Bridge

Pennsylvania approach to Riegelsville suspension bridge
Carries Delaware Road
Crosses Delaware River
Locale Riegelsville, New Jersey and Riegelsville, Pennsylvania
Maintained by Delaware River Joint Toll Bridge Commission
Design Suspension bridge
Total length 577 feet (176 m)
Opened 1904
Toll None

The Riegelsville Bridge is a suspension bridge crossing the Delaware River at Riegelsville, Pennsylvania, connecting it with Riegelsville, New Jersey.

Contents

History

Traffic across the Delaware River at Riegelsville, PA was handled by Wendel and Anthony Shenk's oar powered ferries until December 15, 1837 when a three span, wooden covered bridge was opened to horse, wagon, and pedestrian use. The Pennsylvania and New Jersey legislatures had approved the formation of the private Riegelsville Delaware Bridge Corporation in 1835 and the company engaged Solon Chapin and James Madison Porter of Easton, PA as the contractors. A major flood struck the Delaware Valley on January 8, 1841, just three years after the bridge opened, and the span nearest the Jersey shore was destroyed. The bridge was repaired and survived another flood in June 1862.

The "Pumpkin Flood" occurred on October 10, 1903 and the Delaware waters rose to 33.8 feet (10.3 m) above normal. The two spans nearest to New Jersey were quickly swept down the river. The third section collapsed soon after.

The wire rope and engineering firm of John A. Roebling's Sons, Co. based in Trenton, New Jersey were soon commissioned and replaced the covered bridge with a cable suspension bridge. This new bridge incorporated the original piers which were repaired and raised several feet, allowing it to survive major damage from the flood of 1936 and to come through a 1955 deluge relatively unscathed. Together, the three spans are 585 feet (178 m) in length and the final cost of construction was $30,000. It opened on April 18, 1904.[1]

Roebling's original design for the bridge employed main cables 2.625 inches (6.67 cm) in diameter. Professor James Madison Porter III, the grandson of the builder of the earlier Riegelsville bridge, was asked to evaluate the new design and felt the need for additional cables of 1.75 inches (4.4 cm) diameter which were added to the plans.[2]

The Riegelsville suspension bridge collected tolls until it was purchased by the Joint Commission for Eliminating Tolls and is currently maintained by the Delaware River Joint Toll Bridge Commission[3] using revenues generated from larger, more heavily trafficked crossings. The bridge has a 3 Ton weight limit.

See also

References

  1. ^ Dale, Frank T., "Bridges over the Delaware River",page 106,Rutgers University Press,2003,ISBN 0-8135-3213-2
  2. ^ Richman, Steven M., "The Bridges of New Jersey",pages 112-114, Rutgers University Press, 2005,ISBN 0-8135-3510-7
  3. ^ Riegelsville Toll Supported Bridge, accessed May 7, 2007

External links